FOR
Custom Built 2001 Eliminator 28 Daytona TD
Will Sell With or Without Engines
Click on the thumbnail for Hi-Res Image
Single Owner Boat and Custom Built to My Specs
This Boat is Spotless and Very Well Maintained
Boat and Engines Were Built for Endurance High Speed Running (Poker Runs and Weekend Cruises)
Always Stored in Heated Barn
 
Pair of 540CI Bow Tie Blocks, 625HP Engines by PRI
Less Than 5 Hours on Engines Since Rebuild and Dyno
New Pistons, Bearings, Valves, Valve Springs, Lifters, Oil Pumps
Marine Spec Multi Angle Valve Jobs, Balance Rotating Assemblies
 
Bravo XR Drives with 2" IMCO Shorties
Outdrives Serviced Every 50 Hours
IMCO Standoff Boxes and Hydraulic Steering
Heavy Duty Gimbals with Mechanical Indicators
Billet Drive Caps
Outdrive Temperature Gauges
 
Thru Hull Water Pickups with Sea Strainers
Engine Oil Thermostats
CMI Sport Tube Headers
Custom Breather Can Systems
 
Engine Alarm Lights on Dash Include; Water Pressure, Fuel Pressure, Oil Pressure and Knock Meters
4 person RPM Intercom with Throat Mics
All Engine Alarms Wired To Intercom System and to Dash Buzzers
4 Speaker CD/Stereo
Built In VHF Radio with Audio Amp Wired to Auto Cut Out on Driver Side Stereo Speaker
Handheld Mapping GPS Mounted on Dash to GPS Speedometer
 
Pirelli Flooring With Foot Locker
Custom Cabin Area With Storage Areas
Custom Seat Height, 3" Higher than Standard for Improved Visibility
Lap Straps for Improved Safety
Custom Rear Seat That is Hinged for Easy Engine Access
Locking Cabin Door
Tinted Windshield and Deck Hatch
Camper Top that Can be Used up to 50 MPH
4 Matching Life Line Poker Run Vests
Extra Vents, Extra Pull Up Cleats, Automatic Halon, Stern Rails, Grab Handles
Engine Specs
Callies Crank - Bore and Stroke - 4.505 X 4.250, Manley Rods, Canton Oil Pan
Brodix Heads, Hydraulic Roller Cam, T & D Roller Rockers, Valve Cover Oil Sprayers
MSD Ignition Distributors, MSD Marine Ignition Boxes with Rev Limiters
Tri Axle Extreme Trailer with Disc Brakes
Boat is Located Southeast of Zanesville, Ohio
New Replacement Boat and Engines Would be over $300K
$74,500 with engines
$50,000 without engines and headers
Contact Randy at (740) 965-5973
or email rbtnt@aol.com